Heavy Duty Swing Door Operator
Heavy Duty Swing Door Operator
Technical Features and Functions
- Dimension: (LxHxW): 545 x 107 x 100
- Weight of operator: 12kg
- Drive for one door
- Maximum Opening: 95º
- Power Requirements: 230 VAC / 50Hz;
- IP22 protection
- Opening Time Adjustment: 0-20s
- Separate Inputs for motion detectors, presence sensors and photocells
- DC Output: for Auxiliary sensors and electric lock
- Power failure - doors close by spring
Functions of Control Unit
- Automatic
- Door stand open
- One way traffic
- Two way traffic
- Night lock
- Manual open by hand and closing by spring
- Push & Go (automatic opening by pushing)
- Synchronisation of two operators
- Cyclic opening and closing
Adjustments (via control unit or digital selector)
- Regulation of opening and closing speeds
- Regulation of acceleration and deceleration's.
- Safety sensor inhibiting distance in opening mode
- Pushing thrust limitation
- Pause time (0-20s)
- Wind stop force intensity
- Push and go activation distance
- Intensity of final thrust on closing phase to ensure electric lock is latched.
- Release time of 0.5 seconds for lock before opening of door.
- You can have a right or left opening door, push or pull opening, speed and power opening mode: for every mode of the assembly the same operator can be used.
- Activation of the functions can be selected via the on board 3 way switch on the lateral side of the operator, manual key switch or via a digital selector.
- Programming the functions and parameters can be done by the on board dip switch or via the digital function selector
- the regulation of the opening angle (maximum 95º) must be adjusted at the initial installation of the operator.
- In a power fail situation it can be opened by hand and closed by spring